|
Rates/Factors |
  
|
|
Rates/Factors |
|
Within EnergySteward.com you can record and save critical rates and factors associated with your meters/wells. These rates and factors are typically utilized for volume conversions (MMBTU to MCF, etc.). Because these rates/factors can change for a meter/well (over time), their is a 'from date' and 'thru date' assignment for each meter/well rate/factor entry. Below is a sample screen shot on where these rates and factors are added or updated for a meter/well.
Add Rate/Factor (button) - Click this button to add a new rate/factor entry for the meter/well.
View/Edit Grid Button (pencil) - Click this next to the applicable rate/factor entry in order to change any of the information relevant to the entry.
Delete Grid Button (red x) - Click this next to the rate/factor that you want to permanently delete. When you delete a rate/factor, then only the specific meter/well rate/factor is removed. Important note: You will be presented with a confirmation ("Are you sure...?") dialog box prior to deletion.
The following shows the rate/factor detail which you are presented with when adding or updating a meter/well rate/factor.
General (tab)
Effective From (popup calendar) - This is a required field. It will default to '01/01/1800'. This should be left at the default value unless date effectiveness for this rate/factor is important.
Effective Thru (popup calendar) - This is a required field. It will default to '12/31/3000'. This should be left at the default value unless date effectiveness for this rate/factor is important.
BTU Factor - Optional. Enter the BTU factor (if applicable) for the time period.
Pressure Base - Optional. Enter the pressure base (if applicable) for the time period.
Pipeline Pressure Base - Optional. Enter the pipeline pressure base (if applicable) for the time period.
Measurement Factor - Optional. Enter the measurement factor (if applicable) for the time period. This measurement factor typically utilized in oil run ticket net calculations.
Compression Factor - Optional. Enter the compression factor (if applicable) for the time period.
Comments - Optional. Enter any comments/notes concerning this meter/well rate information, if applicable.
Measurement Calculation Information (tab)
Tap Type - Optional. Enter the tap type on this meter/well. Informational only.
Tap Location - Optional. Enter the location for the meter/well tap. Informational only.
Static Range - Optional. Enter the meter/well static range. Informational only.
Diff Range - Optional. Enter the meter/well diff range. Informational only.
Temp High Range - Optional. Enter the meter/well high temperature range. Informational only.
Temp Low Range - Optional. Enter the meter/well low temperature range. Informational only.
Base Temp - Optional. Enter the meter/well base temperature. Informational only.
Tube Size - Optional. Enter the meter/well tube size. Informational only.
Orifice Size - Optional. Enter the meter/well orifice size. Informational only.
Calculation Type - Optional. Enter the meter/well measurement calculation type. Informational only.
Energy Basis - Optional. Enter the meter/well measurement energy basis. Informational only.