|
Update Status Codes |
  
|
|
Update Status Codes |
|
When you publish a new report into EnergySteward.com, the system must verify/register it before it can be used within the reporting menus. The report will go thru multiple 'stages' as it gets published. These status codes indicate the available status codes which get set as the system goes through its verification/registration process. Important note: These values should normally never be modified as they are used by the background report program services.
The screen shot below shows the initial screen which lists out your available report update status codes:
Add Program Type (button) - Click this button to add a new report update status code.
View/Edit Grid Button (pencil) - Click this next to the applicable report update status code in order to change the information about this code.
Delete Grid Button (red x) - Click this next to the applicable report update status codes that you want to permanently delete. Important note: You will be presented with a confirmation ("Are you sure...?") dialog box prior to deletion.
Update Status Name - This represents the name of the update status names.
Notes - This is where you can post any information relative to the report update status codes.
Is Report Status Code Active (checkbox) - If checked, then this program status code is considered active.